Applying Pain Adaptability to Manual Therapy Practice

This proof-of-concept study uses an observational design to assess correlation between the below stated factors. This study design has been recommended in analgesic management in investigating novel mechanistic relationships. A convenience sample will be recruited from outpatient orthopedic clinics and University sites across a geographically diverse segment of the United States. Individuals will be educated on the purpose and risks of the study via informed consent and will determine if they would like to participate. An a priori power analysis was performed at the .05 significance level with a projected correlation of (.60) and a sample size of 28 participants was recommended to achieve 80 percent power. Given the single session design with virtual/electronic follow up a low dropout rate related to compliance is anticipated. Given the noxious application and the ability to terminate session if requested, along with aforementioned, a total drop-out rate of 10% will be anticipated. A sample size of 32 will be utilized in an attempt to obtain 28 participants.

Data collection will be completed by investigators and/or clinicians whom have been trained directly by investigators on the research protocol or by the research team.

Following consent, the individuals will follow the protocol below:

1. Baseline patient reported measurements will be obtained including McGill Pain Questionnaire, Fear Avoidance Belief Questionnaire, Modified Oswestry Low Back Pain Disability Questionnaire, Expectations of Treatment Scale, Hospital Anxiety and Depression Scale, Fatigue Severity Scale, Numeric Pain Rating Scale (NPRS) (current, best, and worst)

2. Baseline Demographics which have shown prognostic value

   1. Age

   2. Gender

   3. Symptom Duration

   4. Joint(s) involved

   5. Presence of referred leg pain

3. Baseline Objective measures will be obtained including:

   1. Active Range of Motion at lumbar spine and Coxofemoral joint

   2. Neuromuscular Screening (Reflexes, light touch sensation L3-S1, neural testing)

   3. Cardiopulmonary screening (Blood pressure, heart rate, pulse-oximetry, AAA)

   4. Joint mobility at lumbosacral spine via Posterior -> Anterior (PA) mobilizations performed central and unilateral; Assess for comparable sign, If present progress to below

   5. Pain modulation/adaptability assessment - Protocol outlined below:

   6. Application of non-thrust Central or Unilateral PA mobilization application as chosen by the clinician in a pragmatic manner to address patients comparable sign.

      • Technique, grade, time, and location to be recorded

      • Pain (NPRS) to be graded continuously throughout the technique and recorded

   Pain Adaptability/Modulation assessment:

   Throughout the experiment, the participants will sit comfortably in a chair with arms rested on the arm rests and legs testing on the floor. The room temperature will be controlled at 21-23 deg C. Participants will be assured that cold stimulation will not cause any physical damage to their body, and are allowed to withdraw from the experiments at any time.

   Cold pressor pain

   • A bucket of ice and water, a temperature of 1.0C to 4.0C will be maintained by stirring regularly to prevent an increase of water temperature surrounding the hand.

   • Participants will submerge their left hand to 5cm above the wrist with their palm facing down. They will be encouraged to keep their hand in the water for 5 minutes. If they find the pain becoming intolerable, they can withdraw their hand immediately.

   • Pain intensity - During the cold stimulation, participants will be asked to rate the intensity of pain continuously using a 0 to 10 NPRS (0 = no pain at all; 10 = worst pain possible).

   • McGill Pain Questionnaire (MPQ) - will be completed after cold stimulation. The MPQ is designed to provide qualitative and quantitative measures of pain that can be examined statistically. The MPQ consists of 4 major classes of word descriptors (sensory, affective, evaluative, and miscellaneous) for participants to specify subjective pain experience.

   • Pressure pain threshold (PPT) - An electronic pressure algometer (Pain Test FPX 25) with a probe area of 1 cm squared will be used. Participants will indicate when the pressure stimulus becomes just painful. PPT's will be determined by averaging 3 assessments taken at 1-minute intervals. It will take 2 to 3 minutes to complete the PPT tests, which will lead to some participants undertaking a 6-minute cold stimulation test.

   • Sensory assessment - All PPT assessments will be tested at 3 sites: bilateral extensor carpi radialis, at 3 cm distal to the lateral end of the cubic crease on the elbow, and on the right soleus at 8 cm proximal to medial malleolus.

   • All PPT Assessments will be performed before, during (3 minutes after the initiation of cold stimulation), and 20 minutes post termination of Cold Stimulation.

4. 2-week follow up via phone call, text message, email, or virtual meeting to assess NPRS and GROC.